SS ISO 294-5 Ed. 1 (2011)被替代
Plastics - Injection Moulding Of Test Specimens Of Thermoplastic Materials - Part 5: Preparation Of Standard Specimens For Investigating Anisotropy
出版：Standardiserings-Kommissionen I Sverige
专家解读视频
基本信息
标准编号： SS ISO 294-5 Ed. 1 (2011)
发布时间：2011/4/20 0:00:00
标准类别：Standard
出版单位：Standardiserings-Kommissionen I Sverige
标准页数：20
标准简介
Describes a two-cavity mould (designated the type F ISO mould) for the injection moulding of 80 mm x 90 mm plates with a preferred thickness of 2 mm for single-point data acquisition because 2 mm has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection.
替代本标准的新标准
