DS EN ISO 294-5:2013被替代
Plastics - Injection Moulding Of Test Specimens Of Thermoplastic Materials - Part 5: Preparation Of Standard Specimens For Investigating Anisotropy
出版：Danish Standards
专家解读视频
基本信息
标准编号： DS EN ISO 294-5:2013
发布时间：2013/3/2 0:00:00
标准类别：Standard
出版单位：Danish Standards
标准页数：24
标准简介
Defines a two-cavity mould (designated the type F ISO mould) for the injection moulding of 80 mm x 90 mm plates with a preferred thickness of 2 mm for single-point data acquisition because 2 mm has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection.
替代本标准的新标准
